DELL EMC DES-DD23 Dumps – Pass DES-DD23 Exam On The First Attempt

DELL EMC DES-DD23 Dumps – Pass DES-DD23 Exam On The First Attempt

You will be guaranteed to pass the DES-DD23 exam on the first attempt, if you choose ITPrepare DELL EMC DES-DD23 dumps. DES-DD23 exam is for the Specialist – Implementation Engineer, PowerProtect DD Version 3.0 certification. The DES-DD23 dumps covering each exam objective and topic could be your great learning materials for preparation. Just find out the best DELL EMC DES-DD23 dumps from ITPrepare to pass your exam now.

Below are free DES-DD23 demo questions for checking:

Page 1 of 2

1. A technician is upgrading a DD9400 with a DS60 expansion shelf with 60 drives. In the GUI interface, only 30 drives are accessible.

What is causing these drives to be inaccessible?

2. What are some key benefits of performing backups and recoveries with a PowerProtect DD appliance?

3. DRAG DROP

What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?



4. A backup administrator has enabled the Retention Lock feature on their PowerProtect DD appliance. Over time, the administrator noticed an increase in file system utilization. Upon further investigation, the administrator discovered expired files are still present on the appliance.

What is the most likely reason for this issue?

5. Which are supported compression algorithms in DDOS?

6. An administrator is configuring a Google Cloud Provider cloud unit on their DD9900 .

Which certificate must be imported before adding the cloud unit?

7. An administrator has retained snapshots for a single MTree and is trying to create a new one. An error message is received.

What is the reason for the failure?

8. Refer to the exhibit.





To which shelf and port should SAS HBA slot 1 port B be connected?

9. A customer needs a backup system to protect 100 TB of mission-critical data .

What should be used to back up the system?

10. When the PowerProtect DD system boots up for the first time, the CLI configuration wizard script does not start automatically.

Which command can be used to start the script manually?


 

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *