Enterprise Routing and Switching Professional (JNCIP-ENT) JN0-649 Practice Exam Dumps

Enterprise Routing and Switching Professional (JNCIP-ENT) JN0-649 Practice Exam Dumps

Juniper JN0-649 exam is a professional-level exam for Enterprise Routing and Switching certification track to verify your understanding of advanced routing technologies and related platform configuration and troubleshooting skills. To help you prepare for the Juniper JNCIP-ENT JN0-649 exam well, ITPrepare has completed the JN0-649 practice exam dumps online. With ITPrepare’s Juniper JN0-649 practice exam dumps, we promise your success in the Enterprise Routing and Switching Professional (JNCIP-ENT) certification. We guarantee that you will pass your Juniper JNCIP-ENT JN0-649 exam with flying colors.

Juniper JNCIP-ENT JN0-649 Free Demo Questions Are Online Also For Learning

Page 1 of 2

1. You are asked to establish interface level authentication for users connecting to your network. You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability.

Which authentication method would satisfy this requirement?

2. Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)

3. The connection between DC1 and DC2 is routed as shown in the exhibit.

In this scenario, which statement is correct?

4. Referring to the exhibit, which two statements are correct? (Choose two.)

5. Your enterprise network uses routing instances to support multitenancy. Your Junos devices use BGP to peer to multiple BGP devices. You must ensure that load balancing is achieved within the routing instance.

Which two statements would accomplish this task? (Choose two.)

6. Referring to the exhibit, how will router E quickly learn that the remote MAC addresses are no longer reachable through the router attached to the failed link?

7. You are troubleshooting an EVPN-VXLAN IP fabric and observe the loop shown in the exhibit.

Which two steps would you take to further troubleshoot this problem? (Choose two.)

8. Referring to the exhibit, anycast RP is implemented to ensure multicast service availability.

The source is currently sending multicast traffic using group and R3 is receiving PIM register messages, but R2 does not have active source information.

In this scenario, what are two methods to receive the active source information on R2? (Choose two.)

9. You are running OSPF as your IGP. The interfaces connecting two routers are in the ExStart state. You notice that something is incorrect with the configuration.

Referring to the exhibit, which statement is correct?

10. Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?


Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *